Follow

Some parts from a Performance do not appear to sound.

Applies to: SuperNova, SuperNova II

The preset Performances use between 1&6 parts each. Most of the layered Performances only use 2 or 3 Parts. The remaining parts have been deactivated by setting the polyphony to "off". If these parts are required, set the polyphony to either "poly"," mono" or "prog". A setting of "Poly" will set the part to play more than one note at a time (polyphonic), A setting of "Mono" will set the part to play one note at a time (monophonic), A setting of "Prog" will set the part polyphony to follow the polyphony setting already used in any program which is then assigned to the part - eg if a monophonic program is assigned to a part, the part polyphony will be monophonic.

Other causes of parts not sounding are: a part volume level of 000 has been received; the MIDI channel for the part is incorrect; the part range or velocity switching for the part is incorrect; the part has been set to a different audio output pair.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Didn't find what you were looking for?

Search again using our search tool.