Applies to: K-Station
There is a bar graph that is displayed next to a parameter name. When this bar graph occupies the most screen space the original value has been found. Alternatively turn the local control off. This stops the K-Station from responding to its front panel directly. Instead, any changes you make are transmitted as MIDI messages. Usually, the local control is turned off to enable a MIDI device to be used in a full MIDI loop with a sequencer - it avoids a unit from receiving two change messages, one directly and one via MIDI
However if you set the K-Station local control to off and do not route generated MIDI data back into the K-Station, then when you make a change from the front panel, the stored parameter value will be displayed. Remember to turn the local control back on once you have seen all the values you need otherwise you will not be able to control the K-Station properly - you will not be able to change patches for example. See page 35 in the K-Station manual for full details on local control.