The Vocoder section doesn't work on my A-Station

Applies to: A-Station

If the vocoder is being used with a microphone double check that the input sensitivity has been switched from "Lo" (the factory default) to "Hi". This is the correct sensitivity for a microphone or for a guitar. Next adjust the audio input trim for the best signal level. Dial up one of the vocoder presets - 259, 269 or 279 and play notes on the A-Station at the same time as talking or singing into the mic. The vocoder effect should be audible. For more information on the input sensitivity and input trim see pages 52 and 53 in the A-Station manual (54 & 55 in the A-Station v1.1 manual).

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request