Follow

Automap HUI error message in Logic

Applies to: Automap, Impulse, SL Mk II, Nocturn, UltraNova

If you encounter the following error in Logic, follow the steps below to re-install the HUI control surface in Logic.

Device "HUI" is assigned to MIDI Port "Automap HUI" which is not present.

Please ensure that all MIDI interfaces are connected and switched on. If this is the case, please check the MIDI port setting of device "HUI". If this is correct, click "Reset All MIDI Drivers" in Preferences > MIDI > General.




1. Open LOGIC PRO > PREFERENCES > CONTROL SURFACES > SETUP

2. Click the existing HUI control surface image



3. Select EDIT > DELETE

4. CLick NEW > INSTALL

5. Choose MACKIE DESIGNS > HUI > HUI then click ADD

6. Check the ENVIRONMENT > CLICKS & PORTS section is set up as detailed in the Logic DAW setup guide.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Didn't find what you were looking for?

Search again using our search tool.