Applies to: Nocturn keyboard
Nocturn Keyboard Calibration Initial Setup
Make sure you have installed the latest version of Automap from our website.
Connecting a programmed unit and selecting calibration mode
Connect the Nocturn Keyboard to a computer. While holding octave up and down buttons down together,turn the Nocturn Keyboard on. Keep these two buttons pressed down until buttons 1 to 4 and button 8 is lit. The octave ‘-‘ and ‘+’ buttons will be flashing.
This indicates that the keyboard is in calibration mode.
There are 4 features to calibrate – the pitch wheel, the mod wheel, the aftertouch sensitivity and the keyboard length.
Calibration Order:
1) pitch wheel
2) mod wheel
3) aftertouch sensitivity
4) keyboard length
Once the calibration has been setup, this needs to be saved to the unit (this is not automatic).
Pitch Wheel Calibration
While watching the first encoder ring move the pitch wheel through it’s full range of travel once. This calibrates the unit. The calibration can then be checked by moving the pitch wheel through a full range of travel a second time.
At position 1 (pitch wheel minimum), only the first LED of LED ring 1 should be lit
.
At position 2 (pitch wheel maximum), all 11 LEDs for LED ring 1 should be lit.
At position 3 (pitch wheel spring back to centre), the first 6 LEDs of LED ring 1 should be lit.
Mod Wheel Calibration
While watching the second encoder ring move the mod wheel through it’s full range of travel once. This calibrates the unit. The calibration can then be checked by moving the mod wheel through a full range of travel a second time.
At position 1 (mod wheel maximum), all 11 LEDs for LED ring 1 should be lit.
At position 2 (pitch wheel minimum), only the first LED of LED ring 1 should be lit.
There is no spring for the mod wheel, so the centre position is not critical and does not need to be checked.
Aftertouch Calibration
The LEDs around encoder 3 register the aftertouch output. The 4th encoder is used to calibrate this output and the LED ring around encoder 4 shows the calibration value.
Press firmly and keep holding a key on the keymech (of the order of 30 N to 40). Turn encoder 4 anticlockwise until less then 11 LEDs are lit around encoder 3. Now slowly turn encoder 3 clockwise until all 11 LEDs are lit around encoder 3. Check 2 or 3 other keys can be pressed firmly and all 11 LEDs are lit around encoder 3. If not, turn encoder 4 clockwise slowly again until all 11 LEDs are lit for this key.
Keyboard Length Calibration
Press both the top key and the bottom key simultaneously and release both keys.
Save Calibration Settings
The calibration settings are not automatically saved. These must be saved to the manually saved to the unit In order for these settings to be retained on the unit, press button 8 on the unit.
The unit will then reboot.