Applies to: SuperNova II Keyboard

The following describes the calibration procedure for the pitch wheel, mod wheel and aftertouch on the Supernova II keyboard:

1. Power on with */octave down/* pressed. Keep it pressed until the wheel calibration page displays.
2. Move both wheels to their extremes several times. As soon as both have moved significantly, the display shows responses to wheel movement.
3. Check that the bend wheel (left) causes the left-hand number to change between 0-254 with 254 displayed at maximum positive displacement.
4. Check that the mod wheel (right) causes the right-hand number to change between 0-127 with 127 displayed for maximum positive displacement. 
5. Press */page down/* when done – this produces the aftertouch calibration page.
6. Hold one key firmly down.
7. Adjust the upper number (with the upper data knob) until the lower number just reaches its limit of 127.
8. Add 10 to the upper number.
9. Try pressing a few keys and confirm that any key can produce a lower numerical value of 127.
10. A typical value for the upper number is 100. A value below 70 or above 150 should be treated with suspicion.
11. Press */page down/* when done – this saves calibration data in flash memory.