How to connect Launchkey Mk1 to an iPad.

Applies to: Launchkey Original

To connect your Launchkey to an iPad, you will need:

  • Your Launchkey
  • Your Launchkey USB cable
  • An iPad
  • An Apple USB camera connection kit (not included)

You must plug the USB cable into the Launchkey Mk1 first, then plug the other end into the Camera Connetion Kit. Finally connect the camera connection kit into the iPad.

If you change the order of connection you may receive an error message on the iPad screen saying 'this accessory is not supported' or 'the attached accessory uses too much power'.

Note: this article only applies to the Launchkey Mk1 not Launchkey Mk2


Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request