When using Automap, I have a control which is modifying two plugin parameters at once, how can I stop it?

Applies to: Automap

This can happen if your DAW is receiving MIDI CC data from your controller and Automap is also controlling the plug-in. The CC message output by the controller may modify one parameter while Automap's been set to modify another.

Please ensure that you have followed the DAW setup guide for your DAW software or consult your host software's documentation to find out how to prevent MIDI data from your controller's ports being routed to MIDI tracks in your sequencer.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request


Didn't find what you were looking for?

Search again using our search tool.