Follow

The Supernova/SuperNova II arpeggiator does not run.

Applies to: SuperNova, SuperNova II

The arpeggiator in Supernova can be synchronized to an incoming midi clock signal sent from a sequencer. To accomplish this, set the clock source found in the global menu to EXT (external) or Auto (Supernova II only). Ensure that midi clock is being transmitted from your sequencer into the correct midi port for the Supernova. The sequencer must then be put into either play or record mode, as the Supernova needs a song start message for the arpeggiator to run. If the arpeggiator still does not run, double check that midi clock is being transmitted from the sequencer NOT Midi Timecode (MTC). The Supernova cannot respond to MTC.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Didn't find what you were looking for?

Search again using our search tool.