Applies to Summit
To select a single patch for either part A or B of the Summit in Multi mode:
- Press Multi to take you to the Multi patch menu
- Press Page > to see the currently used patch on the currently selected part (e.g press the A part button to see the patch loaded for part A and then B button to see the patch loaded for part B)
- Note that they are all shown as occupying Bank A, Patch 000. This is to allow you to select an alternative single Patch (or Init Patch) to modify the overall sound of the Multi Patch.
- When on page 2 and the desired part is selected you can press the top left button next to the screen and then use the data encoder/value +/- buttons to move through the patches for that part. This is drawing from the bank of single patches on the unit